[Operation Instructions]
(1) Due to the characteristics of the converter, if the installation quantity(capacity) is lower than the capacity, light flickering may occurs.
This is not a defect of the dimmer.
(2) Flickering occurs from the 0% to 40% brightness range of the dimmer. Use is recommended above the 40% brightness level.
(3) Noise may occur in some brightness ranges during adjustment, but this is a characteristic of the dimmer and does not affect the operation of the product.
(It is much lower compared to similar products.)
[Precautions]
(1) Ensure that the operating voltage of the dimmer and converter matches the voltage of the connected products (loads).
Using mismatched voltages can damage the products.
(If using DC 24V, the dimmer, converter, and the connected products must all be DC 24V.)
(2) Check the polarity (+, -) of the products before connecting them.
(3) Adhere to the capacity limits for each terminal.
- 200 units of 3 LED modules per terminal / Parallel wiring in units of 50(2 terminals / total 400 units)
- PCB aluminum bars within 10M (max. parallel wiring in 3M units / PCB in 2M units)
(4) This product is exclusively for DC 24V LED (PCB) bars, aluminum bars, and LED modules.
Do not use it with other products.
(5) Be careful to avoid moisture ingress, arbitrary disassembly, and impact, as these can cause serious damage to the product.
[NOTE]
Defects caused by not following these precautions will not be covered by warranty or replacement.